The light will glow solid Amber for about 30-45 seconds while it starts up, then blink Amber. Plug in your Airport Express unit to the wall (this will not necessarily become its permanent location - you will be able to move it later). Connect the Ethernet cable to the router on one end, and to the Airport Express unit on the other end.ģ. Get a cat5 Ethernet cable (anything but an orange cable - that's a crossover cable) like you would use to connect your PC to your router to pick up the Internet.Ģ. (Note: These directions assume your DSL/Cable Modem is hooked up to a wireless router or acts as its own wireless router)ġ. Nice - but no one really tells you how to set up the Airport in client mode.ĭo yourself a favor, toss that user manual aside and run these steps. If you read through the manual, the Support section here, etc., you will hear lots of talk about "Client Mode" - and that this is the only way to get it to work. This can make you think you need to buy another piece of hardware to make it work. When you look at the picture diagram they provide, they show Airport Express picking up its signal from another Apple-oriented base. Unfortunately, Apple's user manual is very unclear how to connect Airport Express to your own network. And, you don't need the printer sharing capability nor creation of another wireless network (2 of the features of Airport Express). Say you already have your own home network set up, and all you want is to be able to use AirTunes to play music off iTunes into your speaker system. After spending 2 hours last night installing this on my father-in-law's home network, I hope to be able to save someone else the agony we went through. You can connect a Switch to the Ooma Telo Home port, and connect serveral devices to the Internet through the Ooma Telo Home port function.I am posting this for everyone tearing their hair out trying to connect the Airport Express to your own existing home wireless network. (An Ooma Telo reboot may be required after the network cable is disconnected from the Ooma Telo Internet port). Then go into Ooma Setup>Wireless page and place an check mark in the box in front of Network Name, then click on the Delete button, (you cannot reuse the previously scanned and entered Wi-Fi network information). If you get this far and the Ooma works okay, go back into the Apple Airport Express and set the Wi-Fi network security level to WPA2PSK/AES (or near this level). Make sure you have the Wi-Fi Internet connection. Enter the Apple Airport Express Wi-Fi password. Place a check mark in the box in front of the Network Name that you plan on using (your Apple Airport Express Wi-Fi network). Then go into Ooma Setup>Wireless page and place an check mark in the box in front of Network Name (if there is any networks found), the click on the Delete button, (you cannot reuse the previously scanned and entered Wi-Fi network information). Next access the Apple Airport Express and temporarily set the Wi-Fi security level to off. Using an Ethernet cable, connect the HOME NETWORK port on the back of your Telo to a computer) nothing works.įirst make sure the Apple Airport Express Wi-Fi network is setup and has a password. dapter-faq (Plug the Adapter into the USB port on the back of your Telo. ![]() If I follow the connection instructions on. After a short time the Wireless Settings Screen says "No active wireless networks" and network name is "none." It also allowed me to go to and scan for wireless networks, select mine, enter the password. That allowed Ooma to connect and deliver a dial tone. Turn on the Modem, wait til it gets online, then Ooma, wait until all lights turn blue, then turn on Airport Express. Connect Airport Express to Ooma's "Home Network" port.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |